(another AWG2 to the aux battery, double ground wire at the alternator, removed the AWG2 wire from the relay to the fuse block and direct connected the battery wire to the relay (fuse on the battery) and cleaned and flattened all the connections) You may not see the 80A numbers shown above with a stock MB install. I went through the system beefing up the wiring. I should mention that when I used the AGM factory aux battery I had a problem of early low voltage inverter shut down due to voltage drop in the wires to the aux battery. The wimpy MB battery wire (AWG 2) is likely limiting the current through the relay. So I regularly see much higher than 40A and so far (couple of years) have not had any problems.Īll that being said, it's not a good idea to design for the max on any component. This is current in and out of the house battery only through the relay since there are no other loads. This quickly drops to 60A and tapers to 0 depending on house batter state of charge. My battery monitor shows -80A of load when the relay turns on after start (house battery charging engine battery) and then +80A once the alternator kicks in. The relay is most highly stressed when it closes or opens under load. I have no idea what the specs on the relay are. And Broussely warns: “Certainly discuss this with your battery manufacturer. >Float charging Li-ion cells is possible, but the voltage-temperature-lifetime-capacity trade-off is complex. Assume I’ll be using the Tripp Lite combo Inverter/Charger I mentioned at the start. Since T-105s gas float (some, less than charging) added a 2nd monitor to disable the cut off relay when 14.2 is reached, no float charging, not a lot if hands on with this loop, learning. I think I’ll stick with NOT having shore power mess with my starter battery (to avoid the different technologies problem). With a time factor programmed, if battery voltage is less than 12.1 for 3 minute's, a reset is required, no more high amp loads or it will happen again with less time due to less AH/voltage available. Whether a H4 or H7 headlight bulb or something different we stock the largest range of quality bulbs. Use voltage set point, when a load is active the battery voltage is always less than non load. Repco has the right headlight bulb for your vehicle. I'm using a BMV 700 to prevent the battery voltage from descending thru 12.1 volts, 50% SOC, programmed the BMV to open relay/output, opens an interposing relay that disables all loads from battery's. Do you use a battery monitor to control the cut off relay (relay under seat)? Only Li batt hand's on I have has been held in my hand, phone's etc. I did limited research on the Li batt loop, had some ?s Just went with T-105's 450 AH bank, thinking more plug and play with the MB system, put a shore charger on every so, done.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |